ESP8266 Community Forum

Posted: **Fri Nov 27, 2015 5:01 pm**

Hi guys,

Hope you're doing an exciting experience with the ESP8266 modules.

Here is my struggle. I just received a new ESP8266 module. At my first experiment, I just wanted to power it up.

I'm using an external 3.3V breakout board to power the module. I connected (Vcc & CH_PD) pins of the module to +3.3V of the power supply and the GND of the module to GND of the Power Supply.

The red LED in the module just lit up at the very first second of completing the circuit, then it goes off. and the power supply goes so hot and it's power LED gets so much dimmed.

the power supply works fine with any different device.

So I hope you guys help me out as quick as possible. I'm just at the first step of my journey with that module. and I'm locked up there.

Regards.

Posted: **Sat Nov 28, 2015 1:04 am**

Which module? There are many. Some have pretty specific needs.

Posted: **Sat Nov 28, 2015 4:57 am**

sounds like you have a short somewhere...

Posted: **Sat Nov 28, 2015 6:15 am**

Timpanogos Slim wrote:Which module? There are many. Some have pretty specific needs.

Hi Timpangos. Thanks for reply. I do appreciate it.

Here is the data of the module I have:

I purchased it onlin, the title of the product was:
ESP8266 WIFI network module RS232 control AT

What is written on the main chip is:
ESP8266EX
282014
POVV01

regards.

ESP8266 Community Forum

A problem with power up ESP8266

A problem with power up ESP8266

Re: A problem with power up ESP8266

Re: A problem with power up ESP8266

Re: A problem with power up ESP8266