arduino and esp8266 interface problem
Posted: Fri Feb 05, 2016 3:11 pmso at first i connected my arduino to esp8266 using this tutorial:
http://www.instructables.com/id/Beginners-Guide-to-ESP8266-and-Tweeting-Using-ESP8/?ALLSTEPS
it was helpful. in this tutorial i connected the TX to TX by converting it to 3.3 volts and i connected RXto RX and it worked pretty well. i updated the firmware too but at the end of this tutorial and any thingspeak related projects there is a GET or POST command that im supposed to insert either in code or using serial monitor and it doesnt work for me.
i've checked almost every tutorial on the net but i just dont get it.
can anyone help me?
http://www.instructables.com/id/Beginners-Guide-to-ESP8266-and-Tweeting-Using-ESP8/?ALLSTEPS
it was helpful. in this tutorial i connected the TX to TX by converting it to 3.3 volts and i connected RXto RX and it worked pretty well. i updated the firmware too but at the end of this tutorial and any thingspeak related projects there is a GET or POST command that im supposed to insert either in code or using serial monitor and it doesnt work for me.
i've checked almost every tutorial on the net but i just dont get it.
can anyone help me?