ESP8266 Community Forum

Posted: **Sat Feb 20, 2016 4:19 pm**

ok, i bought this one

i thought it was gonna be easy to setup but something is wrong or maybe i just doing wrong :-)

.. i have driver for ch340 from ch340.ch in windows10 as the same chip in my arduino!

I succeeded to connect to the chip the first time, i send over first example code and but then the setup starts to connect/disconnect randomly with the usb so now it seems i cant rewrite it. But i cannot confirm it bricked either...

Now it wont respond to anything, well, sometimes it do but.... yey..

what can i do and what should i do?

Posted: **Sat Feb 20, 2016 5:44 pm**

If you hadn't gotten a squeak out of it at all I would have said, looking at the photo, that the module wasn't aligned properly and pins were shorting. What development environment are you using? Arduino IDE? ESPlorer?

Posted: **Mon Feb 22, 2016 10:48 am**

AdrianM wrote:If you hadn't gotten a squeak out of it at all I would have said, looking at the photo, that the module wasn't aligned properly and pins were shorting. What development environment are you using? Arduino IDE? ESPlorer?

The problem were solved with other driver for ch340g. Seems that there are three different types of driver for one chip......

well, thanks anyway.

ESP8266 Community Forum

setup issues.. not knowing what im doing wrong...

setup issues.. not knowing what im doing wrong...

Re: setup issues.. not knowing what im doing wrong...

Re: setup issues.. not knowing what im doing wrong...