ESP8266 Community Forum

Hi,
I need to read several sensors (8 to 12).
I have been reading a lot (and I am very new to electronics) and I am not sure if this can be done....

My Idea is to connect 2 CD74HC4067 to a ESP8266 12.
The would share the GPIO 5 6 and 7, GND, 5v. With this they would activate the needed Analog pin of the CD74HC4067.
One CD74HC4067 would be for reading the A signal from one of the sensors and the second CD74HC4067 would be for the realy (to send the 3 or 5 v that the sensor needs). The second CD74HC4067 would have an extra pin connected to GPIO 8 that would activate it in this mode....

Does this make sense?

Hi,

It make sense to me.

I want to read also up to 16 analog signals from soil moisture sensors.

I found the following website. Maybe something usefull for you.

http://bildr.org/2011/02/cd74hc4067-arduino/

Same site I was looking at.
I will have to wait until I get the 2 boards.
currently I need 4 sensors.... I have finally come up with a solution.... a bit messy but works.... I will wait until I get the boards before actually making the circuits.

Same problem i have.

I have ordered also 1 board, but waiting for delivery.