ESP8266 Community Forum

- Sat May 07, 2016 8:59 am #47050 Hello,
I have nodemcu v3 (esp8266 12e) but I can not connect to specific router with this module - here is router config:
ZTE SpeedPort entry router (see image http://imgur.com/9WKOXfx)

It always says It is in connecting state,

Code: Select allscandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (19)
reconnect
f -180, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (19)
reconnect
f r0, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (19)
reconnect
f 0, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (19)
reconnect
f -180, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (19)
reconnect
f r0, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (19)
reconnect
f 0, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (19)
reconnect
f -180, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (19)
reconnect
f r0, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (19)
reconnect
f 0, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (19)
reconnect
f -180,

- Wed Jul 13, 2016 12:59 pm #50704 Hi, I have a similar issue on Cisco AP in our office. Laptop using WPA2_PSK works fine, ESP won't connect. Home router (Linksys with DD-WRT) and WPA2_PSK works fine too.

Code: Select allsetup for type 1
mode : sta(5c:cf:7f:88:1f:06)
add if0
f r0, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (12)
reconnect
f 0, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (12)
reconnect
f -180, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (12)
reconnect
f r0, scandone
state: 0 -> 2 (b0)
state: 2 -> 3 (0)
state: 3 -> 0 (12)
reconnect