- Wed Feb 24, 2016 5:26 am
#41794
common both GND (USB to ttl's AND esp's) << most common problem
GPIO^00 = 3.3v (normal using)
GPIO^00 = GND (for flash OR burn firmware)
GPIO^02 = 3.3v
GPIO^CH_PD = 3.3v
GPIO^15 = GND
baud rate must be 9600
put button between RST and GND for reset module
that's it.
:-i prefer that you change only GPIO^00 >>3.3 OR GND AND check only result with 9600 baudrate
:-just forgot all other baudrate that recive any kind of garbage like>> "RST CAUSE:2, BOOT MODE: ___(3,6)" and blah blah.........any kind of
:-and other pins as i say
i just remind you again >>
just forgot all other baudrate that receive any kind of ..
garbage like>> "RST CAUSE:2, BOOT MODE:(3,6)" [set it only on 9600]
and set pins status as i say >> changes are only on GPIO^00 >>3.3 OR GND..
GPIO^00 = 3.3v (normal using)
GPIO^00 = GND (for flash OR burn firmware)
GPIO^02 = 3.3v
GPIO^CH_PD = 3.3v
GPIO^15 = GND
baud rate must be 9600
put button between RST and GND for reset module
that's it.
:-i prefer that you change only GPIO^00 >>3.3 OR GND AND check only result with 9600 baudrate
:-just forgot all other baudrate that recive any kind of garbage like>> "RST CAUSE:2, BOOT MODE: ___(3,6)" and blah blah.........any kind of
:-and other pins as i say
i just remind you again >>
just forgot all other baudrate that receive any kind of ..
garbage like>> "RST CAUSE:2, BOOT MODE:(3,6)" [set it only on 9600]
and set pins status as i say >> changes are only on GPIO^00 >>3.3 OR GND..
