- Sat Apr 02, 2016 4:49 pm
#44691
Hi,
After loads of different setups connecting my 8266 to my Arduino Uno I'm stuck.
As of now I use an external 3.3v powersource connected to Vcc, CH_PD and RESET.
I have my Arduino TX connected to the 8266 TX using three resistors to bring down voltage.
When I connect the "end resistor" of this line to the external GND I get a constant blue light and when I type in the Serial monitor I get no response but the text I write apears as out.
If I put that resistor to the Arduino GND I get no blue light and no response at all.
I have experimented around a bit but I as the lights are working and there have been no heavy smoke drifting along my desk I don't think I've burnt it.
I'm no electronics wizard, does anyone have a clue?
After loads of different setups connecting my 8266 to my Arduino Uno I'm stuck.
As of now I use an external 3.3v powersource connected to Vcc, CH_PD and RESET.
I have my Arduino TX connected to the 8266 TX using three resistors to bring down voltage.
When I connect the "end resistor" of this line to the external GND I get a constant blue light and when I type in the Serial monitor I get no response but the text I write apears as out.
If I put that resistor to the Arduino GND I get no blue light and no response at all.
I have experimented around a bit but I as the lights are working and there have been no heavy smoke drifting along my desk I don't think I've burnt it.
I'm no electronics wizard, does anyone have a clue?
