- Fri Sep 23, 2016 10:43 pm
#55599
I have been following the steps as outlined in this OTA tutorials.
http://esp8266.github.io/Arduino/versio ... dates.html
Using BasicOTA.ino , I have set SSID, Password, upload via serial and gotten IP address via serial monitor successfully. I am able to find the OTA port after uploaded via serial.
My termite error log is as below:
Start
Progress: 0%
Error[2]: Connect Failed
Error[4]: End Failed
I have used different ESP8266 nodemcu and wemos rf mini. Both are working boards for other non-OTA programming. I used 2 different laptops and also tried my phone hotspot instead of home WIFI.
How can I debug the connection error? Is it the port limit? I have comment off to turn on the port definition and password. The authentication works until I see the connection errors.
http://esp8266.github.io/Arduino/versio ... dates.html
Using BasicOTA.ino , I have set SSID, Password, upload via serial and gotten IP address via serial monitor successfully. I am able to find the OTA port after uploaded via serial.
My termite error log is as below:
Start
Progress: 0%
Error[2]: Connect Failed
Error[4]: End Failed
I have used different ESP8266 nodemcu and wemos rf mini. Both are working boards for other non-OTA programming. I used 2 different laptops and also tried my phone hotspot instead of home WIFI.
How can I debug the connection error? Is it the port limit? I have comment off to turn on the port definition and password. The authentication works until I see the connection errors.
