ESP8266 Community Forum

- Sat Jul 18, 2015 2:30 pm #23592

Nope ! In your latest drawing you are actually shorting the GPIO to VCC.
Simply switch resistor and button on your original diagram, making the button connected to GND and the resistor to VCC, acting as a PullUp.

image.jpg

Thanks a lot, it worked!

- Sat Oct 15, 2016 6:32 am #56548 hé thanks that fixes my boot problem! just keep it high on boot!
(I pulled the pin to low instead of high so now I understand the chip enters the wrong boot mode... )