ESP8266 Community Forum

- Tue Apr 28, 2015 3:19 am #15887 Hmm Now my ESP is goin to Zombie mode again.

Have anyone see this problem, men using low power batterys ?
It look like the the Zombie mode starts, if the power drops to ~2.8-3.0V If I then give more power to ex. 3.3V then Zombie mode still is there. If I then flash the "INTERNAL://BLANK" then my ESP suddenly is morking perfectly again, for hours.
It's realy strange. I can bring back my ESP to work again, after flash the BLANK. But if I puzzel the ESP with some 2xAA batterye (low voltags)... then bang!!! The Zombie comes back after some minutes, and I can only resolve this by BLANK flashing ?!?!

Thanks

Best regards

- Tue Apr 28, 2015 11:56 am #15921

Hmm Now my ESP is goin to Zombie mode again.

Have anyone see this problem, men using low power batterys ?
It look like the the Zombie mode starts, if the power drops to ~2.8-3.0V If I then give more power to ex. 3.3V then Zombie mode still is there. If I then flash the "INTERNAL://BLANK" then my ESP suddenly is morking perfectly again, for hours.
It's realy strange. I can bring back my ESP to work again, after flash the BLANK. But if I puzzel the ESP with some 2xAA batterye (low voltags)... then bang!!! The Zombie comes back after some minutes, and I can only resolve this by BLANK flashing ?!?!

Thanks

Best regards

That sounds familiar: https://github.com/nodemcu/nodemcu-firmware/issues/387

Get your modules here:

https://www.banggood.com/custlink/KvGGhGF4wG

- Wed Apr 29, 2015 3:01 am #15980 Hi Cal.

It sounds like, that SDK 1.0 is solving many problems with node.dsleep, at NodeMCU will not develop on that, the reason to the low heap
Do you have any luke to make a setup with LUA and SDK 1.0 ? I real want to help and are ready to test. But I'm not god a programmer.

Thanks and best regards

- Wed Apr 29, 2015 5:01 am #15991

Hi Cal.

It sounds like, that SDK 1.0 is solving many problems with node.dsleep, at NodeMCU will not develop on that, the reason to the low heap
Do you have any luke to make a setup with LUA and SDK 1.0 ? I real want to help and are ready to test. But I'm not god a programmer.

Thanks and best regards

Moin delinend,

I don't know how many "god" programmers are here Hmmm, if you ask anonymously you may get a lot of votes ; -)

raz123 pointed here (https://github.com/nodemcu/nodemcu-firmware/issues/360) to
https://github.com/chadouming/nodemcu-firmware and some more candidates.

I didn't have the time to test that yet. You can give it a try.

Cal

Get your modules here:

https://www.banggood.com/custlink/KvGGhGF4wG