I type this..
setenv sta-mode hcp
and I get a boatload of control characters coming back
saveenv
again a boatload of control characters followed by the message "Writing environment to flash ... DONE"
reset
and it resets - but then when I type this
iwmode STA
iwconnect east-wing 1921681266
I get another load of control characters and it is not connecting to the access point. Nothing wrong with the access point as it works perfectly on other software.
I must be missing something - have I typed the right commands.. and what are all the control characters for???
Necromant wrote:Lotus wrote:Thought this would be a good thread to ask a specific question:
- is there a way to get the RSSI of the connected link in STA mode apart from disconnecting and doing a site scan?
Not with their 'wonderful' API. But you can scan without disconnecting.
I notice in their API documentation they have a 'promiscuous mode' but not too much information about how to use it.
I suppose a wifi_station_scan can be done with channel and bssid identifiers and that should theoretically execute faster.
Lotus wrote:Necromant wrote:Lotus wrote:Thought this would be a good thread to ask a specific question:
- is there a way to get the RSSI of the connected link in STA mode apart from disconnecting and doing a site scan?
Not with their 'wonderful' API. But you can scan without disconnecting.
I notice in their API documentation they have a 'promiscuous mode' but not too much information about how to use it.
I suppose a wifi_station_scan can be done with channel and bssid identifiers and that should theoretically execute faster.
you can use attached example
I want to reach out with something other than these prehensile paws and feel the solar wind of a supernova flowing over me.