ESP8266 Community Forum

- Tue Sep 08, 2015 4:07 pm #28654 It is having trouble uploading to the board.

Check the wring of you USB to serial adapter and or if you have gpio 0 grounded.

Serial terminal in the chrome browser see https://serialTerminal.com

http://esp8266basic.com
A BASIC interpreter for your ESP

Working now on Autodrop3d. A 3d printer with automatic part ejection system. https://autodrop3d.com

- Tue Sep 08, 2015 5:24 pm #28660 If you are still having this error, it's because the IDE cannot make contact with your esp.
Make sure you have a hefty power supply going to your esp (mine is 1.5A, regulated down to 3.3v). This alone fixed several issues I was having.
Also, you may want to build a circuit like this (http://www.xess.com/blog/esp8266-reflash/) if you don't have t his already, to make sure you enter flash mode reliably. My circuit works about half the time, but then again it's built on a breadboard, which may be picking up EMI/RFI or buttons may be bouncing, etc.

- Wed Sep 09, 2015 12:26 am #28674

It is having trouble uploading to the board.

Check the wring of you USB to serial adapter and or if you have gpio 0 grounded.

I'm running it from the arduino (chipless) but I think the wires may not be connecting properly.

ajb2k3.wordpress.com

I suffer from a bad case of random misfiring synapses!

- Wed Sep 09, 2015 12:35 pm #28724 Tried the power adapter and still nothing!
ordered a ftdi dodad.
all pins are connected a supplies to the correct pins, tried swapping txd and rxd around and got packet delevery failure so switched around

ajb2k3.wordpress.com

I suffer from a bad case of random misfiring synapses!