ESP8266 Community Forum

- Fri Nov 21, 2014 1:27 pm #3099 Yes, thank you. The picture is enough for me to understand. I wonder why the reset is working, because through these pads the reset pin is connected to the gpio16 pad...
Anyway I'll test is too when I have them.

- Fri Nov 21, 2014 3:25 pm #3105 According to schematic, the pads seems to be the resistor between pin32 and pin 8 of the chip, so, normal behavoir should be that GPIO16 drive the XPD_DCDC and if we wish also to connect it to EXT_RSTB, we need to add this resistor on the pads.

Attachments

ESP-03.jpg (35.27 KiB) Viewed 3942 times

- Mon Nov 24, 2014 12:47 pm #3239 thoose pads connects gpio16 and reset pin. i soldered thoose pin and tried sleep mode and its perfectly working
deepsleep power state is 0.038-0.043 ma mean 38-43 µa on esp-03

ESP8266.com Moderator
Lets get the party started and +1

[url=https://www.banggood.com/custlink/KvGGhGF4wG[/url]

I like ESP8266 and ESP8285 and ESP32

- Tue Dec 02, 2014 3:54 am #3791

thoose pads connects gpio16 and reset pin. i soldered thoose pin and tried sleep mode and its perfectly working
deepsleep power state is 0.038-0.043 ma mean 38-43 µa on esp-03

Do you mean the jumper near VCC and GPIO14?
Did you used a resistor or just a wire?