ESP8266 Community Forum

- Tue Oct 27, 2015 2:13 pm #32395 Do you have any plans to implement I2C in MMISCOOL basic? This would be good for expanding I/O, using displays, and many other things.

Thanks for this firmware! AWESOME!

- Tue Oct 27, 2015 7:15 pm #32413 Instant wish fulfillment mode on.

I had added I2C function some time ago but have not documented them yet.

Still need to do that but don't really have any i2c devices to test with.


Basic function = arduino function

i2c.begin(address as number) = Wire.beginTransmission(address as number);
i2c.write(stringToWrite) = Wire.write(StringToWrite);
2c.end() = Wire.endTransmission();
i2c.requestfrom(addressAsNumber,numberOfCharacters) = Wire.requestFrom(Address,NoOfBytes);
i2c.available() = Wire.available());
i2c.read() = Wire.read();

Keep in mind these have not been tested.

I2c is set on pins 0 and 2

Arduino docs for i2c functions is at the following link.
https://www.arduino.cc/en/Reference/Wire/

Serial terminal in the chrome browser see https://serialTerminal.com

http://esp8266basic.com
A BASIC interpreter for your ESP

Working now on Autodrop3d. A 3d printer with automatic part ejection system. https://autodrop3d.com

- Thu Oct 29, 2015 12:40 am #32512 Pin 0 = clk
pin 2 = dat

or vise versa?

Thanks, will try I2C as soon as board shows up.

- Thu Oct 29, 2015 6:20 am #32535 Also, what are you calling pin 0 and 2?

I have seen many different IO numbering methods used for esp8266 in the past. Can you provide a link to the pinout your are using?