ESP8266 Community Forum

- Fri Dec 04, 2015 5:01 am #35624 Ok, now try to change the SPI speed at 10Mhz, then 20 and so on to find where the problems begin!

- Fri Dec 04, 2015 12:14 pm #35656 yes, i will try bumping up the speed gradually after Jan 2016. Will be on vacation

- Sat Dec 05, 2015 3:24 pm #35745 A new release, uses the new font rendering engine for user converted fonts.
https://github.com/sumotoy/TFT_ILI9163C/tree/Pre-Release-1.0r4

- Mon Dec 07, 2015 9:43 am #35874 Hello,

ive tested the new Version an a Nodemcu 1.0.
It works only a few seconds, than i got the message:

started

Exception (28):
epc1=0x402035ae epc2=0x00000000 epc3=0x00000000 excvaddr=0x01010404 depc=0x00000000

ctx: cont
sp: 3fff0cd0 end: 3fff0e90 offset: 01a0

>>>stack>>>
3fff0e70: 00000000 00000000 3ffefe58 402035ab
3fff0e80: 00000000 00000000 3ffefe70 40100114
<<<stack<<<

ets Jan 8 2013,rst cause:2, boot mode:(3,6)

load 0x4010f000, len 1264, room 16
tail 0
chksum 0x42
csum 0x42
~ld

Greetings Peter