- Fri Feb 12, 2016 9:10 pm
#41008
has anybody made any discoveries with this?????
Moderator: igrr
- Sat Feb 13, 2016 4:36 pm
#41061
Hi, i'm getting the exact same thing, i've powering it via the 3.3v of the Arduino uno board but. had it working for about 3 days on/off but it just cut out randomly and now is just giving me the CIPStart And AT+RST command. all communication to webserver was working before this. no i cant even get any communication on either side. can any one help me with this or guide me. i know that people on here say that the 3.3v doesn't provide much power to the esp. but i've had it working with no problem at all. somethings gone wrong somewhere all the connections where the same which is just annoying. so would appreciate any help.
- Sun Feb 14, 2016 10:38 am
#41107
Have you tried a separate 3.3 volt supply?
- Sun Feb 14, 2016 1:01 pm
#41118
No, I haven't there is 3.3v going to the ESP though. When I've measured it on a multimeter so theres no problem there. I think somethings internally wrong so might need to reflash it.
JoeO wrote:Have you tried a separate 3.3 volt supply?
No, I haven't there is 3.3v going to the ESP though. When I've measured it on a multimeter so theres no problem there. I think somethings internally wrong so might need to reflash it.
