- Mon Apr 22, 2019 3:20 am
#81959
@holopaul, can you please try this: https://github.com/eriksl/esp8266-unive ... ses/tag/23
- Mon Apr 22, 2019 6:29 am
#81963
I feed both esp the same sensor data. The data flow is this: sensor>uart bridge>network(ip)>processing ide viz on the computer.
You can take a look at this slowmotion (240fps) clip. v22 on the left, v11 on the right side.
https://imgur.com/a/7CuRMKZ
eriksl wrote:@holopaul, the code path for sending data from the network to the UART and receiving from the UART and sending it to the netwerk is completely different. Can you please explain which path you're using (most) and which is having the latency?
When I am testing with the terminal emulator, it looks like network->UART is quite good and responsive, the path from UART->network looks like having some latency, but it can also be just the keyboard key repeat that's slow.
I feed both esp the same sensor data. The data flow is this: sensor>uart bridge>network(ip)>processing ide viz on the computer.
You can take a look at this slowmotion (240fps) clip. v22 on the left, v11 on the right side.
https://imgur.com/a/7CuRMKZ
- Mon Apr 22, 2019 8:09 am
#81965
In this direction an improvement was possible, can you please test? Sending to network is now started immediately and not left waiting for a "slow interrupt" (which isn't that slow, it fires 10 times a second). The drawback is that less data is accumulated, you'll now probably get one byte per packet 
- Wed Apr 24, 2019 8:14 am
#82017
A definite improvement! I will do some tests in the next few days and tell you the results.
Thanks so much!
Thanks so much!
