ESP8266 Community Forum

- Thu May 14, 2015 9:45 pm #17418 Set your serial to 74880bps and post the boot message. This will make things clear immediately.

My ESP8266 dev board https://www.tindie.com/products/Ba0sh1/ ... d-adapter/

- Thu May 14, 2015 10:22 pm #17419

Hi,
A few time ago, I received some of these modules from Espressif. I don't know how these modules should be connected, I have tried different pin configuration on these modules and at least I could flash them with another firmware but they doesn't do anything, just show a line of garbage in the terminal.
I'm using a USB-TTL with a power regulartor LD33V, also I tried with my Arduino UNO.

I have not encounterd those boards but they look good!

--µrt