- Wed Jul 25, 2018 10:36 am
#77423
Hi all
I'm using a WI FI Module and I have the following questions:
1. Just to make sure HSPICS is active low?
2. What is the default state of the module GPIO'S (Input,TRI state....)?
3. Can somebody tell me what is the timing requirements of the Enable and Reset
after power up? I will be glad to get a timing diagram..
Avi Ben-Maor
I'm using a WI FI Module and I have the following questions:
1. Just to make sure HSPICS is active low?
2. What is the default state of the module GPIO'S (Input,TRI state....)?
3. Can somebody tell me what is the timing requirements of the Enable and Reset
after power up? I will be glad to get a timing diagram..
Avi Ben-Maor
