ESP8266 Community Forum

- Mon Oct 19, 2015 6:48 pm #31782 Thanks both for the reply, it turns out that the esp8266 module was slowly dying and therfore doing some really strange things, I checked all my other modules and they operate as expected. Hard to know if I blew it up or not, but I think I will put those pullup resistors in ..

- Tue Oct 20, 2015 1:02 am #31803

GPIO0 must be high and GPIO2 must be low

Small correction : it is the reverse, GPIO2=HIGH and GPIO0=LOW for serial upload.

I stand corrected, thanks!

- Wed Nov 04, 2015 12:26 pm #33036 Setting the PINS, using ESP.restart() instead of reset() did the trick for LAN and KEY PRESS reboots, by the way, does any one knows how to TURN OFF an active softAP() without rebooting ?

if (glbFlagRST) {
Serial << F("\nBOOTING");
unsigned long start = millis();
while (millis() - start < TIMEOUT_3) {
delay(250);
Serial << ".";
yield();
}
digitalWrite(0, HIGH);
pinMode(0, INPUT_PULLUP); // Run Program
pinMode(2, OUTPUT);
digitalWrite(2, LOW);
ESP.restart();
}