ESP8266 Community Forum

- Thu Nov 20, 2014 4:31 pm #3009 That a good question, because I've bring the GPIO16 to GND, and I don't see my ESP-03 doing any reset ...

- Thu Nov 20, 2014 4:32 pm #3011

That a good question, because I've bring the GPIO16 to GND, and I don't see my ESP-03 doing any reset ...

did you tried gnd to nc?

ESP8266.com Moderator
Lets get the party started and +1

[url=https://www.banggood.com/custlink/KvGGhGF4wG[/url]

I like ESP8266 and ESP8285 and ESP32

- Thu Nov 20, 2014 4:38 pm #3014

did you tried gnd to nc?

I've just tried NC, using a 1K pulldown, nothing there too.
I've tried all other pins too, except one, GPIO14, because I broke the pad while doing my breakout, they are so tin.
So, I didn't found any Reset.

- Thu Nov 20, 2014 4:51 pm #3019 I'm a bit stupid : while searching the reset pins and expecting reboot seen in my picocom, my USB-TTL was not connected to my ESP-03, but to my ESP-01 ...
The GPIO16 is in fact the Reset !