- Wed Jun 01, 2016 8:33 am
#48396
I created a new design using the FT231XS chip that has RTS and DTR pins to allow me to program an ESP8266-01 module without holding down a button and powering it up. The two NPN transistors used in other designs should take care of things.
Right now in the Arduino IDE things look fine.
-power is going where it should
-the FTDI com port appears
-programming leds blink for a second but the sketch will not upload
Can someone take a look at the attached schematic to see if anything obvious was left out? I'll poke around with the oscilloscope over the next few days to find the problem.
Mike
Right now in the Arduino IDE things look fine.
-power is going where it should
-the FTDI com port appears
-programming leds blink for a second but the sketch will not upload
Can someone take a look at the attached schematic to see if anything obvious was left out? I'll poke around with the oscilloscope over the next few days to find the problem.
Mike
You do not have the required permissions to view the files attached to this post.
