- Sun Mar 19, 2017 12:23 am
#63916
Code compiles without error, and I get the success message from Platformio when uploading a new sketch. The blue light on the feather flashes while "uploading."
However, the new code doesn't run. When I plug in the feather and view the wifi monitor, I see the AP from the previous sketch I had written. I've tried uploading a few more times, always the same thing happens.
Serial monitor is also completely barren, which is kind of odd because in both sketches I was printing to it. And the AP from the previous sketch is still there.
Has this happened to anyone else before, and how did they solve it? I want to get back to coding...
However, the new code doesn't run. When I plug in the feather and view the wifi monitor, I see the AP from the previous sketch I had written. I've tried uploading a few more times, always the same thing happens.
Serial monitor is also completely barren, which is kind of odd because in both sketches I was printing to it. And the AP from the previous sketch is still there.
Has this happened to anyone else before, and how did they solve it? I want to get back to coding...
