ESP8266 Community Forum

- Wed May 23, 2018 2:46 pm #76053 Hello,
will this scheme work or I need to provide power to Motor Shield's 3V/5V and GND pins as well? I want to connect D1 with Shield using cables only and not stack them using all pins.

Thank you.

- Mon Jun 04, 2018 11:16 am #76271 So...There are only two options... my question is too stupid or too complicated. Which one it is?

Thank you.

- Mon Jun 04, 2018 11:53 pm #76286 Try it out. When seated, all pins are connected. Other motorshields only have signal pins connected. Test if you need RST to be connected.

- Tue Jun 05, 2018 1:03 am #76287 I think you should add the code you are using.
It will help to give you an answer, to all those who deal with this issue.