- Wed Jan 13, 2016 6:44 am
#38666
I don't know, look at your library's docs. You should be able to use any available GPIO-pin for CSN and modify your sketch to use that pin instead of whatever you used on the UNO.
yoavshtainer wrote:if get what you said, i dont need a new leg for CSN?
how i'm supposed to config this pin in the sketch?
until now i used UNO for the nrf24 and there all the pin's config in the librery...
I don't know, look at your library's docs. You should be able to use any available GPIO-pin for CSN and modify your sketch to use that pin instead of whatever you used on the UNO.
