Your new topic does not fit any of the above??? Check first. Then post here. Thanks.

Moderator: igrr

User avatar
By vladvash
#60643 Hi,

I am newbie in ESP+Arduino IDE. I am trying to create and upload easy sketch, which just sends text into Serial at startup time.

Hardware Platform: H801WiFi unit, described at https://eryk.io/2015/10/esp8266-based-wifi-rgb-controller-h801/

Arduino IDE: 1.6.12
Board: Generic ESP8266 Module.

Sketch compiled and uploaded without any issues. But when module restarted Serial Monitors shows booloader info at 74880 baud and nothing happens.

Code: Select all ets Jan  8 2013,rst cause:2, boot mode:(3,2)

load 0x4010f000, len 1384, room 16
tail 8
chksum 0x2d
csum 0x2d
v09f0c112
~ld


As I saw there is quite standard issue, but I didn't found solution for it.
The same sketch at ESP-12 works fine.

Have somebody any ideas?

Thanks a lot!