Without flash any firmware into the ESP-12E, I can blink a LED using the ESP-12E with Arduino. I wish to change the baud rate of the ESP-12E from 115200 to 9600. (I'm not sure whether the initial baud rate is 115200 or not. But I can only see the output of the serial monitor at the baud rate of 115200 so I guess it is.) Can anyone please tell me how to do so? Thank you
Without flash any firmware into the ESP-12E, I can blink a LED using the ESP-12E with Arduino. I wish to change the baud rate of the ESP-12E from 115200 to 9600. (I'm not sure whether the initial baud rate is 115200 or not. But I can only see the output of the serial monitor at the baud rate of 115200 so I guess it is.) Can anyone please tell me how to do so? Thank you