General area when it fits no where else

Moderator: Mmiscool

User avatar
By matherp
#36837 I got these exactly these messages, it was either when loading a 4MB image to a board that was advertised as 4Mb but only had 1Mb or it was when I had upgraded the memory on a board and had got a dry joint i.e. the memory wasn't functioning correctly. I can't remember which.

I suggest you try a smaller image and see if it makes a difference, if not try resoldering the memory pins (and check for shorts)
User avatar
By iw2fvo
#36838 Yes, it is the message that I do have on the terminal at power on.
My esp has 8Mb or 1 MB memory size. This ESP module flashes and works correctly using AT firmware or LUA firmware.
Thanks
User avatar
By forlotto
#36847 It looks to me like you don't understand what basic is ....

It is a different variation of development you do not use esplorer.

I think you need to do some reading and start from the top again...

You flash your device.

Use espbasicflasher http://www.esp8266basic.com/flashing-instructions.html



Then you connect to it via wireless using the web browser

From the web browser you configure it and write your code etc...

Everything is done from the web browser using basic programming language.

View the guide in my signature if you have a nodemcu!

Enjoy...
User avatar
By iw2fvo
#36899 Thanks Forlotto for the reply,
I was just saying that the esp module in my hands operates correctly if flashed with AT firmware, LUA firmware.
I did load those firmware to be sure of the ESP module operation.
What I got on the terminal is what I get after ESP8266basic.com firmware has been loaded.
Could you please post a picture of a good flashing result ( using basic ) result. At the end I do have a small Yellow triangle.
Thanks for all.
Regards