- Mon May 18, 2015 11:57 am
#17764
Is anyone else having problems with 1.0.1SDK? I downloaded the latest AT user1.1024.bin file. I can flash it onto the chip. I can get it to boot once. I can even issue some AT commands. After changing mode to STA or STA+AP and doing a reboot the firmware starts spitting out error codes. This happens for every boot.
Has anyone got 1.0.1 stable?
What did you do to do it?
Are there "older" chips out there which don't support 1.0.1?
Thanks!!!!
I have flashed back to 0.95 and gotten back up, but based on the newer AT commands, I'm afraid some of the old ones write too much to flash. I don't want to burn out the flash.
Has anyone got 1.0.1 stable?
What did you do to do it?
Are there "older" chips out there which don't support 1.0.1?
Thanks!!!!
I have flashed back to 0.95 and gotten back up, but based on the newer AT commands, I'm afraid some of the old ones write too much to flash. I don't want to burn out the flash.
8 Mhz 28 PIN AVR!!!!!
