- Tue Oct 13, 2015 1:44 pm
#31260
Hi Everyone,
In RTOS SDK, I am using UART1 (GPIO2) for debug output. It works fine if on boot up, immediately open serial terminal for debug output. But if I don't open any serial terminal. It continuously output garbage value.
Anyone know this problem.......??????
In RTOS SDK, I am using UART1 (GPIO2) for debug output. It works fine if on boot up, immediately open serial terminal for debug output. But if I don't open any serial terminal. It continuously output garbage value.
Anyone know this problem.......??????
