- Fri Jan 01, 2016 8:40 am
#37627
I've got a nodeMCU dev board v 1.0 and I'm having a few issues with ESPlorer
I can set it to run in station or access point mode through the Arduino IDE & do some basic switching through a web page, but I can't upload code through ESPlorer or Lualoader. None of the macros seem to work.
I'm running linux so I assume it's not a driver issue.
If I set the baud rate to 9600 and cycle the DTS switch with RTS turned on I get serial output from the board and switching pins from the webpage works fine, but nothing else seems to work. I can't even do a file format from the macro or even manually.
If anyone has any suggestions or can point me to a relevant thread I'd really appreciate your input.
I can set it to run in station or access point mode through the Arduino IDE & do some basic switching through a web page, but I can't upload code through ESPlorer or Lualoader. None of the macros seem to work.
I'm running linux so I assume it's not a driver issue.
If I set the baud rate to 9600 and cycle the DTS switch with RTS turned on I get serial output from the board and switching pins from the webpage works fine, but nothing else seems to work. I can't even do a file format from the macro or even manually.
If anyone has any suggestions or can point me to a relevant thread I'd really appreciate your input.
