- Thu Jul 02, 2015 11:41 pm
#22309
I am running the AT command firmware on ESP8266. I am able to put it to deep sleep by sending the command AT+GSLP. But how do I wake up ESP8266 from deep sleep? Is reset the only way? Is it possible to send another AT command to wake it up? Or toggling some input pin to wake it up?
It takes about 20-25 seconds for home assistant c[…]
I tried to upgrade tof my sonoff basic R2 with the[…]
a problem Perhaps you want to define "Probl[…]
Rebooting your router will not give you a faster I[…]
There are no other notifications from esptool.py i[…]
Using the Arduino IDE, you'll learn how to set up […]
In this project, you will post to Twitter using an[…]
In this project, we will build a water level contr[…]
I guess I'm late, but I had the same problem and f[…]
Last night I received my first D1 Minis for a lear[…]
Although I am aware that this is an old post, I fe[…]