- Sat Apr 02, 2016 12:49 pm
#44683
I am getting espcomm failure messages. I pasted the code from spark fun into the boards manager and installed it. Then I tried to get blink going w the Arduino IDE and it gave me espcomm fail. Do I need to install a driver just for this?
It takes about 20-25 seconds for home assistant c[…]
I tried to upgrade tof my sonoff basic R2 with the[…]
a problem Perhaps you want to define "Probl[…]
Rebooting your router will not give you a faster I[…]
There are no other notifications from esptool.py i[…]
Using the Arduino IDE, you'll learn how to set up […]
In this project, you will post to Twitter using an[…]
In this project, we will build a water level contr[…]
I guess I'm late, but I had the same problem and f[…]
Last night I received my first D1 Minis for a lear[…]
Although I am aware that this is an old post, I fe[…]