ESP8266 Community Forum

- Fri Sep 29, 2017 12:02 pm #70460 When you're programming "Manually", you might want to set the board from "NodeMCU" to "Generic 8266 module" in the Arduino IDE.
Personally I would prefer to use a generic module instead, so I would be certain the NodeMCU-hardware will not struggle against me.

You don't have to keep the flash button pressed by the way: just press and hold flash, press and release reset and release flash.

Assumption is the mother of all f*ckups. At least: that's what I'm assuming.

- Mon Oct 02, 2017 5:35 am #70524 Only reason i like the NodeMCU is because of all the power regulation stuff and if I was using it on a different project the Micro USB.

I did try the Generic ESP Module in the arduino IDE but no difference, worked fine using the USB to TTL device i've got but not using the HC-05.

- Sun Oct 29, 2017 3:07 am #71334 Have you been successful?

All you need to do is connect rx-tx, tx-rx (nodemcu-hco5), and ground from nodemcu to gpio 0, which is D3,
the press reset, and upload.

OR

Connect rx-tx, tx-rx (nodemcu-hco5), Hold flash down, press and release reset, release flash & upload.

And of course connect Vcc on Hc05 to 5v on nodemcu or 3.3 also works. And connect ground too.