- Wed May 06, 2015 5:54 pm
#16743
I am using Arduino and using ESP8266 commands to connect to router.
My program can run with single router.
But it is not able to connect to AP (I mean the APs in big office to bridge a same SSID).
I used "AT+CWLAP" to show all routers, it was able to list routers. I can see numbers of APs with same name.
Anyone has this experience, could you please help?
Thanks,
Peter
My program can run with single router.
But it is not able to connect to AP (I mean the APs in big office to bridge a same SSID).
I used "AT+CWLAP" to show all routers, it was able to list routers. I can see numbers of APs with same name.
Anyone has this experience, could you please help?
Thanks,
Peter
