- Wed Mar 09, 2016 6:11 pm
#42785
I have been using Eclipse to flash my ESP8266 12e. I originally thought the process was malfunctioning somewhere, so I hooked up my GPIO2 pin to my USB to UART converter. I got the feedback I was wanting after the flash, but I got something else too. I get the following text repeated after 1s:
no Netgear66 found, reconnect after 1s
f 0, scandone
no Netgear66 found, reconnect after 1s
f -180, scandone
I was trying to figure out where this text could have come from. Earlier I tried and failed to upload an Arduino sketch that would automatically find and connect to my home network connection "Netgear66". That is the only plausible explanation I have for getting this output text. I have cleared the EEPROM with the EEPROMclear sketch and I still get the output. Where else could this output be coming from? Since I uploaded the original sketch I have installed many other sketches, C programs and I have also installed the Espruino firmware, but somehow this has remained on the chip. If anyone can tell me what this text is and how I can get rid of it I would be eternally grateful. Thank you all in advance.
no Netgear66 found, reconnect after 1s
f 0, scandone
no Netgear66 found, reconnect after 1s
f -180, scandone
I was trying to figure out where this text could have come from. Earlier I tried and failed to upload an Arduino sketch that would automatically find and connect to my home network connection "Netgear66". That is the only plausible explanation I have for getting this output text. I have cleared the EEPROM with the EEPROMclear sketch and I still get the output. Where else could this output be coming from? Since I uploaded the original sketch I have installed many other sketches, C programs and I have also installed the Espruino firmware, but somehow this has remained on the chip. If anyone can tell me what this text is and how I can get rid of it I would be eternally grateful. Thank you all in advance.
