ESP8266 Community Forum

- Sat Mar 28, 2015 10:04 am #12819 Very nice, but i cant get it to work properly.
I have burned the "bootloader", At version 0.22.0.0, SDK version 1.0.0

I have tried to upload BlinkWifi, with right password and ssid (The ESP8299 have conected to my network prior to the BlinkWifi-program)

In serial monitor, a lot of messages appears. starting with "wdt reset", some "tail", "checksum", "add if=0" and ending with "scandone".

I cant ping it, asuming it has the same IP-adress as before, and there is also no new users in the list at the router.

TX-RX
RX-TX
CH_PD and VCC to external 3.3v power sup.
GND to external power sup
GPIO0 to GND when writing code and "bootloader"

Arduino ISP 1.6.0

- Mon Mar 30, 2015 9:50 am #13022 Great initiative, however the installer does not work for me. Downloading the latest version, I get "file corrupted error" when I try to install. I have tried several times with the same result.

I also downloaded v. 0.12 setup, which installed ok, but when I run Arduino (1.6.2) there is noESP visible in boards menu. What exact location should be the ESP files installed into?

- Mon Mar 30, 2015 11:23 am #13030

Is there any plans for a Linux version ?

The base is there. I do not have that much experience with Linux. With some joint effort it is possible Are you open to put some time onto it?

Time is something quite in back order for me
But maybe later on I will look at it ...

- Mon Mar 30, 2015 4:59 pm #13064 I can confirm the download is broken