ESP8266 Community Forum

- Sun May 10, 2015 3:17 am #17061 Hello Everyone !!!

I have just started using esp8266.
The board is connected as mentioned in the user guides and internet.

I am also able to locate the WIFI on my Laptop and Mobile.


When I try run AT commands from a hyperterminal client , I am getting different responses than normal.

Like

when I send AT
I receive Px .

When i send AT+RST
I recieve : PUI5EU<0

I have tried different Baud Rates and different Hyper terminal clients.
I get different responses on different clients.

Attached here with a screen shot of terminal response

Help to move ahead.

Thanks and Regards,
Ravi

Attachments

- Thu May 21, 2015 5:00 am #18043 I suggest check out the wiring as per Wiki above top line on page

Get you modules here:

https://www.banggood.com/custlink/KvGGhGF4wG

- Thu May 21, 2015 8:50 am #18066 Most of the ESP modules I have bought through ebay and did not have any firmware on them whatsoever. It's been a while but I think they behaved similar to yours. I had to flash them first to get started. Easiest for me was to get the nodemcu flasher and follow one of the many guides on the net.

Good luck!
John

- Thu May 21, 2015 11:01 am #18076 Oh !
Thank you very much John,
This was an eye opener for me.
I had almost lost faith in esp.
Thank yoy very much.
It would be of great help if you can share some good links to move ahead.

Warm regards
Ravi