ESP8266 Community Forum

- Thu May 14, 2015 2:35 am #17349 Fir successful reflash and reboot . Takes 4-4.5 seconds to flash a full 236KB and then 1-2 seconds to reboot and reassociate. Pretty sweet! The code is still pretty rouch and lacks sanity checks and finish. Plus instructions...

You do not have the required permissions to view the files attached to this post.

- Fri May 15, 2015 2:21 am #17433 Attached is a final patch that adds a sanity check to verify that the stuff being uploaded actually smells like proper firmware. Sadly there's no good checksum over the whole thing and there's also no easy way to distinguish user1.bin from user2.bin.

The user interface at this point is non-existent. I tested it using commands like:

Code: Select allcurl http://esp8266/flash/next
curl -v --data-binary @firmware/user1.bin http://esp8266/flash/upload
curl http://esp8266/flash/reboot


So far nobody has reacted to any of these patches, so I'll assume there's no interest in further work on this and I'll continue in my private repo.

You do not have the required permissions to view the files attached to this post.

- Fri May 15, 2015 4:17 am #17445 Tve, this will be of incredible value and I am following your progress with eager. I haven't tried it yet as I am waiting for it to reach a more mature state before I jump in redoing my project to support it, but take my word that such functionality is well worth the efforts. Please do keep posting!

- Fri May 15, 2015 10:32 am #17483

Tve, this will be of incredible value and I am following your progress with eager. I haven't tried it yet as I am waiting for it to reach a more mature state before I jump in redoing my project to support it, but take my word that such functionality is well worth the efforts. Please do keep posting!

I double that!