- Sun May 17, 2015 8:39 pm
#17705
my setup:
[img width=500 height=216]http://i.imgur.com/LjVcu3a.png[/img]
(i'm using arduino)
in tutorials, the module would start outputting on the console window and show the "READY" status as soon as power was applied.
but my module won't output anything on the console (after setting baud rate: 115200 and etc)
[img width=500 height=216]http://i.imgur.com/LjVcu3a.png[/img]
(i'm using arduino)
in tutorials, the module would start outputting on the console window and show the "READY" status as soon as power was applied.
but my module won't output anything on the console (after setting baud rate: 115200 and etc)
