- Fri May 29, 2015 5:27 am
#18837
So I am guessing sensors can be attached directly to it and sketches written directly to it..... I'm getting pretty excited about this
- Fri May 29, 2015 6:38 am
#18846
Ok, so now i guess my problems begin
I'm trying to upload the HelloServer Sketch and getting an error
warning: espcomm_send_command: wrong direction/command: 0x00 0x08, expected 0x01 0x08
warning: espcomm_sync failed
error: espcomm_open failed
i seem to have GPIO-0 listed on my ESP, this is an image of mine http://smarpl.com/sites/default/files/i ... ce-v01.png
I tried IO0 as that seemed the closest, but obvious not.
Any help much apprictaed, maybe you know a bitter image location
Regards
Steve
I'm trying to upload the HelloServer Sketch and getting an error
warning: espcomm_send_command: wrong direction/command: 0x00 0x08, expected 0x01 0x08
warning: espcomm_sync failed
error: espcomm_open failed
i seem to have GPIO-0 listed on my ESP, this is an image of mine http://smarpl.com/sites/default/files/i ... ce-v01.png
I tried IO0 as that seemed the closest, but obvious not.
Any help much apprictaed, maybe you know a bitter image location
Regards
Steve
- Fri May 29, 2015 6:50 am
#18848
Its been a little while since i setup an ESP-201 so i missed a couple of things sorry. It also needs GPIO-15 connected to GND, and CHIP_EN connected to 3.3v. Some boards have those wired up for you but the ESP-201s don't so you need to connect them yourself. Yes GPIO-0 is the IO0 on your board and GPIO-15 is IO15.
- Fri May 29, 2015 7:11 am
#18852
Yes I found those pins on an other image tried that and still no joy should it be a pull resistor to 3.3v or just a jumper I've tried both anyway.
Which is the most common and for want of a better word recommended esp device
Which is the most common and for want of a better word recommended esp device
