ESP8266 Community Forum

- Wed Jun 03, 2015 7:59 pm #19399 Where can I find a simple AT Command script to:
Start up.
Connect to wireless router.
Connect through the router to a remote website.
Exchange data with the website

Thanks for any help to get me started

Les

- Fri Jun 05, 2015 3:58 am #19524 If you want to do it the hard way go to the wiki above in the black.
If you want to do it easy with Arduino
http://www.esp8266.com/viewtopic.php?f=6&t=2872&start=10
just cut out the sensor stuff

Get you modules here:

https://www.banggood.com/custlink/KvGGhGF4wG

- Fri Jun 05, 2015 3:24 pm #19603 I o not understand the response. I see no wiki in black, above. The link to the Arduino discussion does not address my at command set script question.

- Fri Jun 05, 2015 6:04 pm #19612 The top of this page . In grey -in the menus
It was always black to me until I had my cataracts done

Get you modules here:

https://www.banggood.com/custlink/KvGGhGF4wG