ESP8266 Community Forum

- Sun Jun 14, 2015 3:51 pm #20470 Are all examples expected to work with the new SDK? Whatever I try I can't get any of the CPP examples to work. They either output nothing (but the boot msg) or they output rubbish at full speed.
This could be caused by some mis-configuration on my end but before I spend more time on this I'd like to understand if anybody else is able to compile these with the latest dev kit based on SDK 1.1.1.

- Sun Jun 14, 2015 4:44 pm #20478 Hello Cherts,


any plan to include Webbase by pvvx in your DevKit?

Thks for your great project!

- Wed Jun 17, 2015 7:48 am #20689

Are all examples expected to work with the new SDK? Whatever I try I can't get any of the CPP examples to work. They either output nothing (but the boot msg) or they output rubbish at full speed.
This could be caused by some mis-configuration on my end but before I spend more time on this I'd like to understand if anybody else is able to compile these with the latest dev kit based on SDK 1.1.1.

Answering my own question - the CPP examples won't work without adjusting the linker scripts. Merging the CPP linker scripts (in C:\Espressiv\extra\ld) and the new linker script provided with 1.1.1 (or 1.1.2) did the trick.
I did a couple of additional changes to the linker scripts so I don't have one ready for everybody to share but it's a rather easy merge - if I remember correctly moving two lines over was sufficient.

- Thu Jun 18, 2015 8:36 am #20818 I had to add a 1nF cap to ground on the RST pin to make download to flash work for me. Anyone need the same and is this for noise filtering or timing reasons?