ESP8266 Community Forum

- Thu Oct 30, 2014 10:51 am #2062 Hi, I have ESP-03 modules ( photos attached ) can you please quide me on the simpliest possible way ( hardware wiring and software necessary ) to compile firmware based on IOT sdk and upload it into that module?
Thanks!

Attachments

view.JPG (27.66 KiB) Viewed 8630 times

- Fri Oct 31, 2014 2:31 am #2089 1. Download archive http://www.ex.ua/load/573159486429/134534617
2. Extract to c:\
3. Add to %PATH% C:\Python27\;c:\MinGW\msys\1.0\bin\;c:\MinGW\bin\
4. run make from esp_iot_sdk_v0.9.1\examples\at\
5. using esptool.py flash firmware
a. CH_PD to VCC
b. GPIO02 to VCC
c. GPIO00 to GND
d. GPIO15 to GND

Code: Select allesptool.py --port COM7 write_flash 0x00000 0x00000.bin

reconect power

Code: Select allesptool.py --port COM7 write_flash 0x40000 0x40000.bin

6. to normal start CH_PD to VCC and GPIO15 to GND

PS I try this instruction on clear computer.
And received only one error error

Code: Select allmake: esptool: Command not found
make: *** [firmware/0x00000.bin] Error 127

to resolve this problem, download this archiv(http://www.ex.ua/323914782630) and extract it in dir that exist in PATH evn. For ex in c:\minigw\bin

Last edited by mcsa on Thu Nov 13, 2014 5:50 pm, edited 1 time in total.

- Fri Oct 31, 2014 4:53 am #2091 okay, thanks a lot!

How should I invoke esptool.py to upload via USB port? I use this usb to uart ttl bridge.

Attachments

- Fri Oct 31, 2014 11:05 am #2103 Thanks @mcsa - I've also been trying to play around with this module and hadn't come across the need to pull GPIO15 to GND. Out of interest where did you come across this?
Cheers,
Ben