ESP8266 Community Forum

- Fri Aug 07, 2015 11:00 am #25286 Good day to all of you in this forum,
I have to connect to MCU's using the wifi instead of normal wiring harness.
The MCU' is powered at 3.3V as the two ESP's. The MCU's have an UART I/O available.
UART configuration is 9600 , 8 , n , 1 . The transmission rate is slow.
I have attached an hand drawn diagram to better clarify the layout.
I will appreciate very much to receive any indication and suggestion on how to implement the software.
Thanks in advance for any help on the matter.
Regards,
Ambrogio

Attachments

ESP_UART.pdf

(285.14 KiB) Downloaded 230 times

- Fri Aug 07, 2015 11:24 am #25290 You can start your project by looking at Erik's Bridge https://github.com/eriksl/esp8266-universal-io-bridge
Then adapt it so that you have 2 ESPs, one as AP and the other as STA.

- Fri Aug 07, 2015 8:36 pm #25325 I think esp-link provides what you're looking for https://github.com/jeelabs/esp-link

- Fri Aug 07, 2015 9:24 pm #25328 Yes, that's look good too !