- Tue Sep 15, 2015 1:24 pm
#29094
BTW for my firmware I use the esp-open-sdk, so that's not the problem.
- Tue Sep 15, 2015 1:53 pm
#29099
Had a long post here, realized I completely misread the schematic, and a long post I made was totally irrelevant to this sutaiton. 
And now I can't figure out how to delete a post. Sorry for spamming up the topic!
And now I can't figure out how to delete a post. Sorry for spamming up the topic!
Last edited by metacollin on Sat Sep 19, 2015 3:11 am, edited 1 time in total.
- Wed Sep 16, 2015 9:57 am
#29168
For proper EMI-decoupling, don't just throw in more uF's, especially if that means using a electrolytic capacitor. Better add something with an extremely low ESR, like a ceramic or polyester capacitor. It doesn't have to be large. IMHO the best is to add a combo of a tantalum capacitor (large capacity and low ESR) and a solid state capacitor (like ceramic) to stretch out the remaining very high frequency noise.
- Thu Sep 17, 2015 12:53 am
#29217
limpkin, can you enable any of the LED channels using GPIO? Just turning it on, without any PWM. Does that work?
Also, when you say it reboots - do the LEDs flash on at all, or is there no visual response, and the esp8266 sends a WDT reboot error.
is it always the WDT performing a reboot?
Also, when you say it reboots - do the LEDs flash on at all, or is there no visual response, and the esp8266 sends a WDT reboot error.
is it always the WDT performing a reboot?
