ESP8266 Community Forum

- Fri Nov 21, 2014 2:40 am #3040 Hey Sjaak
Looks great!

I know it's a bit too late now but here is the missing silkscreen overlay with the designators

- Fri Nov 21, 2014 6:55 am #3064 Thanks, I think i got most things sorted out now

- Wed Nov 26, 2014 9:59 am #3334 Finaly came around to test more of the board. It seems to work so we didn't receive a fake chip \o/

Hooked my trusty old buspirate to it and the bootloader talked to me <3:

Code: Select all ets Jan  8 2013,rst cause:2, boot mode:(3,7)

load 0x40100000, len 24236, room 16
tail 12
chksum 0xb7
ho 0 tail 12 room 4
load 0x3ffe8000, len 3008, room 12
tail 4
chksum 0x2c
load 0x3ffe8bc0, len 4816, room 4
tail 12
chksum 0x46
csum 0x46



If someone else uses a buspirate to monitor the bootloader, here are the commands:

Code: Select allHiZ>m 3
Set serial port speed: (bps)
 1. 300
 2. 1200
 3. 2400
 4. 4800
 5. 9600
 6. 19200
 7. 38400
 8. 57600
 9. 115200
10. BRG raw value

(1)>10
Raw value for BRG (MIDI=127)

(34)>51
Data bits and parity:
 1. 8, NONE *default
 2. 8, EVEN
 3. 8, ODD
 4. 9, NONE
(1)>1
Stop bits:
 1. 1 *default
 2. 2
(1)>
Receive polarity:
 1. Idle 1 *default
 2. Idle 0
(1)>
Select output type:
 1. Open drain (H=Hi-Z, L=GND)
 2. Normal (H=3.3V, L=GND)

(1)>2
Ready
UART>
UART>
UART>(1)
UART bridge
Reset to exit
Are you sure? y



- Mon Dec 01, 2014 10:51 am #3715 More pictures about the build

http://dangerousprototypes.com/2014/12/ ... ay-around/