- Fri Oct 23, 2015 11:23 am
#32129
I tried and upload blink prg, but the error msg: warning: espcomm_sync failed
error: espcomm_open failed
any help...
thanks
error: espcomm_open failed
any help...
thanks
Moderator: igrr
- Tue Nov 24, 2015 3:34 pm
#34914
Can anyone confirm if this is accurate? I've been banging my head against the wall trying to resolve this issue with the ESPtool not showing up as the programmer.
FlyingHacker wrote:You do not need to explicitly select ESPtool as the programmer any more. Just Upload like you normally would and it will work. In other words., you do not need to think about esptool. It just works...
Can anyone confirm if this is accurate? I've been banging my head against the wall trying to resolve this issue with the ESPtool not showing up as the programmer.
- Wed Nov 25, 2015 9:48 am
#34962
Yes ! As soon as "Board type" is selected to some ESP and the "Upload using" to "Serial", the uploading tool "esptool" will be the one executed.
(In other words, "Programmer" menu is ignored)
(In other words, "Programmer" menu is ignored)
- Wed Nov 25, 2015 2:45 pm
#34990
No need to select any "Programmer". Select correct ESP board, compile and upload, everything is taken care by the framework.
cybericius wrote:What does it mean "you don't need it on the frontpage anymore"?
Is it enough to select the ESP8266 board, port? In this what is the programmer I need to use? The default? AVRISP mkII?
No need to select any "Programmer". Select correct ESP board, compile and upload, everything is taken care by the framework.
-Venkatesh
