ESP8266 Community Forum

- Tue Nov 03, 2015 3:11 pm #32953 I can't manage to make it work.

I've flashed the 8266 before, when off the board.

After soldering I can't program it anymore.

I'm using Arduino IDE, tried numerous configurations (different type of boards, baud rates, ...) everything.
Revisited all soldering points, I'm using Ams1117 3v3 regulator (I know it doesn't match, but I've managed to get it soldered the way it should be)...

Did anyone managed to get it to work?

You do not have the required permissions to view the files attached to this post.

- Tue Nov 03, 2015 5:47 pm #32963 I think you need to remove a 0 ohm resistor if you use the regulator option. See the comments section here: http://www.dxsoul.com/product/esp-12-es ... jk4-MuFO4Q. From your picture it does not look like you have removed that.

- Tue Nov 03, 2015 6:24 pm #32971 Also the AMS1117 might have a wrong pinout. Most SOT-89 LDOs seem to have the input on the center pin.

- Tue Nov 03, 2015 7:26 pm #32976

Also the AMS1117 might have a wrong pinout. Most SOT-89 LDOs seem to have the input on the center pin.

Yeap,

I've managed that:

You do not have the required permissions to view the files attached to this post.