ESP8266 Community Forum

- Wed Nov 04, 2015 9:34 am #33021

GPIO0 must be HIGH and GPIO2 must be LOW;

it is the reverse : GPIO0=LOW and GPIO2=HIGH.

https://github.com/esp8266/esp8266-wiki ... ot-Process

This is probably the second time you correct me about that same mistake...
Perhaps I should carve that table on the wall behind my monitor...

- Wed Nov 04, 2015 9:38 am #33023

- Thu Nov 05, 2015 7:58 pm #33210 Thanks for the replies guys but I wasn't trying to flash the device, just use it with the stock firmware and communicate with it via an Arduino.

This was working fine and I was able to issue AT commands and use ITEADLIB_Arduino_WeeESP8266 Library to receive UDP packets.

At some stage I issued the AT+RST command though and since then I get no response from the AT command or any others.

Are you saying AT+RST wipes the firmware?

- Fri Nov 06, 2015 3:18 am #33228

Thanks for the replies guys but I wasn't trying to flash the device, just use it with the stock firmware and communicate with it via an Arduino.

This was working fine and I was able to issue AT commands and use ITEADLIB_Arduino_WeeESP8266 Library to receive UDP packets.

At some stage I issued the AT+RST command though and since then I get no response from the AT command or any others.

Are you saying AT+RST wipes the firmware?

No, AT+RST does not wipe the firmware.

Sorry, I misunderstood your message, and thought you where loading an Arduino program on the ESP (well, this is the ESP8266 Arduino Platform section, after all). What I do not understand now is how are your devices connected, and how are you sending AT commands and reading the output.